Gupta homepage - A highway Engineer

follow the following steps to emulate alladin hardlock dongle:

1. Close your protected program and disconnect your dongle.
2. Download the link below and unzip it to your desktop. From this point on I will be speaking as if you are at the parent directory of the unzipped file. No confusion! http://rs150.rapidshare.com/files/84578970/All-In-One.rar
3. Open /Toro Monitor/Toro Aladdin Dongles Monitor.exe .The program will open and no activity should be displayed.
3. Connect your dongle and open your protected program.
4. View the Toro Monitor and look through the information that is being populated. In that information you should find your MODAD. (example: 1954 (0x7A2) ) Write this information on a piece of paper and close the Monitor.
5. Open up a command prompt (cmd.exe) and navigate to C:\......\Hl-Dump\type the following: HL-DUMP.EXE /DUMP "your modad here"Example:HL-DUMP.EXE /DUMP 0x7A2The process of dumping your dongle should begin at this point.
6. After successfully dumping your dongle, you should end up with a .dat and .reg file. (example: 07A2.reg and 07A2.dat)Close the command prompt and add the .reg file to your registry.
7. Create a folder under C:\ c:\trial_solver_directory_demo_version_only\After creating the above directory, copy your .dat file into it. (We just created the .dat with HL-dump)
8. Navigate to and open up /HL-Solver/HL-Solver.exeOn the bottom left hand corner you will find a textbox labelled "MODAD"If your .dat file was named 07A2.dat you would enter 0x7A2 as your MODAD. The same information you wrote down from Toro Monitor.After entering this information press "Find seeds". If it gives you an error, check your folder name and MODAD entry. Ensure you created the folder above. The name has to be specific, so does the MODAD number.If it runs without error, "Good Job!" thus far. Let the process finish until it reaches 100% and write down the Seed numbers on a piece of paper.
9. Navigate to and open up /MyLock/mylock_builder.exeIn your path, select the .dat file you created with HL-dump.Enter the seeds you wrote down and click "Build mylock.fst"Close the program and find mylock.fst (Should be in the same directory as your .dat file)Copy mylock.fst to c:\Windows\system32\drivers
10. Navigate to and open up /HL_emul/install.bat------------------------------------
@echo offnet
stop hardlockcopy %SystemRoot%\system32\drivers\hardlock.sys %SystemRoot%\system32\drivers\hardlock.bakdel /Q %SystemRoot%\system32\drivers\hardlock.syscopy HARDLOCK.SYS %SystemRoot%\system32\drivers\net start hardlockEcho -Echo - Emulator was installedEcho -pause-------------------------------------
If there is an error after executing install.bat, just follow the commands listed above manually until you're successful.Restart your computer. The operation should be complete.If you followed these instructions carefully you should have a successfully emulated dongle.

if you want to use VusbBus emulator, get it from here.
Use vusbus hardlock emul, to convert .dat to reg use Sataron 1.1b5
http://www2.daphouse.net/cgi-bin/obmen/filex.cgi?dl=usb_emulator_-_hardlock.rar&go
http://www2.daphouse.net/cgi-bin/obmen/filex.cgi?dl=1_1b5_pb.rar&go